High intensity IR emitter for Husky HyPET

Sun, 05 Jul 2026 10:28:40 +0800

Introduction

We built this high-intensity IR emitter specifically for the KHS Husky HyPET blow molding platform. It’s a direct-fit upgrade, plain and simple. Its whole job? Deliver steady, even heat across the PET preform. The kind of heat you can count on, cycle after cycle. That’s how you lock in consistent timing and stop scrap from sneaking in when hot spots drift.

Power, Voltage, and Thermal Density

In blow molding, you need heat fast—but you also need control. So we designed this lamp to concentrate serious thermal energy into a tight space. It heats quickly without over-cooking the preform wall. We matched the voltage and wattage to the HyPET’s electrical specs. That means the lamp pulls its rated load cleanly, without straining the existing wiring. And the length? The arc length? Both are sized to fit the heating station exactly. So you can swap it in as a replacement without reworking brackets or fighting for clearance. Here’s the reality check: high-intensity output needs airflow. If the machine’s cooling path is too small, heat builds up and components can drift outside their safe operating range. When you install it, take a moment to verify airflow and check the reflector condition.

Husky on Industrial Warm IR Heaters

High intensity IR emitter for Husky HyPET

Introduction

Power, Voltage, and Thermal Density